Vibrating Cock Ring Mold

TheEngineerOfJoy

This is a mold to cast a vibrating ring. Just insert a standard vibrating bullet with 1.7cm diameter and enjoy.
The plug is tapered off to one end. The inner diameter of the vibrating bullet insert is 1.4cm so that it fits snug into place.
Download and print in 0.1 to 0.2 mm layer height, 30%ish infill and use medical grade silicone to cast the ring. Good silicone to use is Dragon Skin by smooth-on or TFC Silicone Rubber.
Basically you can use every food-safe silicone with a grade: Shore A 10-25.

1. Sand down the inner surfaces of both molds so that when combining top and bottom, no excessive top layers interfere with each other.
2. Insert the plug and cast the silicone into the mold.
3. Use strong clamps to hold both parts together and let it cure.
4. ….enjoy!

Dimensions:
The mold creates a ring of 2cm inner diameter and 4cm outer diameter. A silicone with a very low soft silicone (Shore A of 10 to 25) is necessary. I am not resonsible for damages to your health 🙂

Share for a discount

Simply share this and a discount will be applied to your purchase at checkout.

Share onShare on FacebookTweet about this on TwitterShare on Google+Share on LinkedIn