Revelizer

"When your fingers aren't long enough" Intended to be held with two fingertips inserted in the bottom. To check if it fits, put your middle-finger and ring-finger together and measure the width over the outermost knuckles. If width is less then or equal to 34mm (just over 1.5inch) it should…

"One big thumb up the ass!" Dimensions: Total height: 130mm Knuckle Ø: ~35mm Base Ø: ~70mm Insertable length: ~90-120mm

"It´s a Shaved Cactus!" Prints without support. Finish it using instructions found on this site. Slide it in. Hint1: You could pause the print and change colour of the filament just after the pot is done. Hint2: Then put it on a shelf and pretend it is a decoration :)…