Ball Gag

SexCadPro

A nice simple 1.75″ (44.45 mm) hollow ball gag with plenty of air (drool) holes. If printed 1:1, it will allow up to 0.8″ wide strap to pass through. This was printed using PLA (remember ABS can be toxic) using a raft (remember it is a round ball), with the strap slots vertical. with 12% infill, without supports (because of the gentle curve there is no issue with no supports), and 0.20 mm layer heights. It took about an hour and 37 minutes to print. It took about 12.67 grams (0.028 pounds) to print the 226 layers.

Dimensions:
1.75″ (44.45 mm)