Tits clamp

Kokinou

Tits clamp DIY Just add your own chain to your clamp. Dimensions: Length : 5cm Width : 2cm

Shark Nipple Clamp with Screw

Boris van Galvin

Some times you just need a little more pressure 🙂 Screw type nipple clamps with a hole in the tail allowing for the addition of some rope or chain. I found that printing the screw and nut at a reslotion of 0.1 at with 6 solid layers and an infill …

Twrex Nipple Teaser

Pierrimus

If dinosaurs are your thing than this Tyrannosaurus themed nipple teaser is sure to please. Suggest printing at .2 mm layer height, without supports and with bridging . Tie a string to two in order to make it easier to tug on (crochet nylon in picture). Dimensions: 57 mm long, …

Triceratops Nipple Teaser

Pierrimus

This Jurassic themed Triceratops nipple teaser comes out of the swamps into your bedroom for fun. Suggest printing at .2 mm layer height, without supports and with bridging. Tie a string to two in order to make it easier to tug on (crochet nylon in picture). Dimensions: 79 mm long, …

Scissor Nipple Teaser

Pierrimus

Cut through to pleasure in the bedroom with this scissor themed nipple teaser. Suggest printing at .2 mm layer height, without supports and with bridging . Tie a string to two in order to make it easier to tug on (crochet nylon in picture). Dimensions: 55 mm long, 40 mm …

Parrot Nipple Teaser

Pierrimus

This avian themed nipple pinch toy can spice your bedroom up. Suggest printing at .2 mm layer height, without supports and with bridging. Unlike my other nipple teasers, this one is not meant to be flipped over to create the mirror. Tie a string to two in order to make …

Dog Nipple Teaser

Pierrimus

Get her ruffing with this K9 themed nipple teaser. Print at .2 mm layer height or better without supports and with bridging on. Link two together with string (crochet nylon in the picture) to allow easy tugging. Dimensions: 42 mm long, 38.5 mm wide, 6 mm tall

Star Nipple Teaser

Pierrimus

Titty nipple teaser shaped like a star. Print at .2 mm layer height or better without supports and with bridging on. Link two together with string (crochet nylon in the picture) to allow easy tugging. Dimensions: 48 mm long, 46 mm wide, 6 mm tall

Alligator Nipple Teasers

Pierrimus

Alligator themed pinching clips. Print two and link them with string (I used crochet nylon in the pictures) for your partner to tug. Print in place without supports as it will bridge. Dimensions: 60 mm long, 18 mm wide, 12 mm tall

Demon Bat Nipple Pincher

Pierrimus

This nipple clip will pinch harder than my other two teaser designs due to the dual spring action. Pinch both sides of the wings to open fully. This is a print in place part and doesn’t need supports as bridging will work. Print two and tie them together with string …