Shaved Cactus

Revelizer

“It´s a Shaved Cactus!”

Prints without support.
Finish it using instructions found on this site.
Slide it in.

Hint1: You could pause the print and change colour of the filament just after the pot is done.
Hint2: Then put it on a shelf and pretend it is a decoration 🙂

Dimensions:
Total Length: 199mm
Insortable length: 160mm
Cactus Ø: 30 – 36,5mm
Pot Ø: 33 – 50mm (not intended for internal use but who am I to  judge)

Share onShare on FacebookTweet about this on TwitterShare on Google+Share on LinkedIn